PP Pleated Water Fitler Cartridge
A PP pleated water filter cartridge is a type of water filter that uses polypropylene (PP) as the filtering material. PP is a type of plastic that is known for its strength, durability, and chemical resistance. PP pleated water filter cartridges are typically used in pre-filtration applications, where they remove large particles and contaminants from water.
PPL series pleated water filters are made of polypropylene, with high retention rate, high flow rate, high dirt holding capacity, high filtration efficiency and low cost.
With extensive chemical compatibility, used for filtering various acid base and solvent.
Application
Biotech: Cell Culture, Direct Flow Filtration, Process Workflows, Single-use solutions
Food & Beverage: Wine, Beer, Cider, Distilled spirits, Non Alcoholic Drinks Dairy, Food& Ingredients Cannabis, Utilities
Chemicals & Polymers: Process water, Chemicals, Petrochemicals
Microelectronics:Semiconductors, Data Storage, Display, Graphic Arts, Photovoltaic
Oil &Gas: Upstream, Midstream, Downstream, EPC
Power Generation: Combined cycle plants, gas turbines, nuclear plants, steam plants, renewable
Desalination plant: RO Plant pre-filtration
PP pleated water filter cartridges work by passing water through a series of pleated polypropylene sheets. The sheets are designed to trap particles and contaminants as the water flows through them. The size of the particles that can be removed by a PP pleated water filter cartridge depends on the size of the pores in the polypropylene sheets.
PP pleated water filter cartridges are a popular choice for pre-filtration applications because they are effective at removing a wide range of particles and contaminants. They are also relatively inexpensive and easy to maintain.
Technical Specification
Material: PP
Filtration Rating: 0.1~70 Micron
Filtration Area: 0.6~0.7㎡/10″
Max. Operating Temperature: 80℃
Ordering Information
PPL 0100 10 C1 E
Series | Micron | Length | End Cap Type | Seal Material | ||
PPL | 0020=0.2μm | 05=5″ |
| C1=226/Spear | E | =EPDM |
| 0045=0.45μm | 10=10″ |
| C2=222/Spear | S | =Silicon |
| 0100=1.0μm | 20=20″ |
| C5=222/Flat | V | =Viton |
| 0300=3.0μm | 30=30″ |
| C6=226/Flat | P | =FEP |
| 0500=5.0μm | 40=40″ |
| C9=DOE |
|
|
| 1000=10μm |
|
|
|
|
|
| 2000=20μm |
|
|
|
|
|