Pleated Water Filters with High Dirt Holding Capacity
HPPV series filter cartridges are made of multi-layer Nano-fiber materials, which have high fouling capacity under reasonable gradient structure design.
The multi-stage interception characteristic of gradual pore diameter from thick to fine makes the filter cartridge have stronger fouling capacity, can effectively improve the problem of rapid surface blockage, greatly extend the service life of the filter cartridge, suitable for filtration of high suspended particles, colloidal substances, high viscosity liquid, etc.
Pleated water filters with high dirt holding capacity are filters that can hold a lot of dirt and other contaminants without clogging up.
They are made with a pleated design, which creates more surface area for the filter to trap impurities. This means they can go longer before needing to be replaced compared to other filters.
They can remove sediment, dirt, sand, and even some bacteria and viruses from water, making them an efficient and effective way to improve water quality.
Application
Biotech: Cell Culture, Direct Flow Filtration, Process Workflows, Single-use solutions
Food & Beverage: Wine, Beer, Cider, Distilled spirits, Non Alcoholic Drinks Dairy, Food& Ingredients Cannabis, Utilities
Chemicals & Polymers: Process water, Chemicals, Petrochemicals
Microelectronics:Semiconductors, Data Storage, Display, Graphic Arts, Photovoltaic
Oil &Gas: Upstream, Midstream, Downstream, EPC
Power Generation: Combined cycle plants, gas turbines, nuclear plants, steam plants, renewable
Desalination plant: RO Plant pre-filtration
Technical Specification
Materials Construction
Filter Media | Polypropylene |
Drainage | Polypropylene |
Cage/Core/End Caps | Polypropylene |
Operating Characteristic
Maximum Operating Temperature | 80℃ |
Maximum Positive Difference Pressure | 4bar/21℃ |
2.4bar/80℃ |
Filter Efficiency
HPPV | ＞95% | ＞98% | ＞99.8% | ＞99.9% |
0.5μm | 0.3 | 0.5 | 0.65 | 0.8 |
0.8μm | 0.65 | 0.8 | 1.0 | 1.2 |
1.0μm | 0.8 | 1.0 | 1.2 | 1.5 |
1.5μm | 1.2 | 1.5 | 2.0 | 3.0 |
Ordering Information
HPPV 0500 10 C1 E
Series | Micron | Length | End Cap Type | Seal Material | ||
HPPV | 0050=0.5μm | 05=5″ | C1 | =226/Spear | E | =EPDM |
0080=0.8μm | 10=10″ | C3 | =222/Spear | S | =Silicon | |
0100=1.0μm | 20=20″ | C5 | =222/Flat | V | =Viton | |
0300=3.0μm | 30=30″ | C6 | =226/Flat | P | =FEP | |
0500=5.0μm | 40=40″ | C9 | =DOE | |||
1000=10μm | ||||||
2000=20μm | ||||||
4000=40μm | ||||||
7000=70μm | ||||||
9000=90μm | ||||||