Orange-Peel Melt Blown Filter Cartridge, PLM Series

The orange-peel melt blown cartridge uses a textured, dimpled outer surface for enhanced mechanical strength and pressure resistance. Its dimpled profile provides additional structural rigidity under elevated differential pressure, which suits high-viscosity liquids and duty where the pressure across the element runs high within its rating.

The problem it addresses is deformation. A depth cartridge pushed by a thick fluid or a steep pressure drop can compress, and a compressed depth structure no longer holds its grade. The orange-peel texture stiffens the outer face without changing the media: 100% polypropylene, graded 1, 3, 5, 10, 20, 30 or 60 µm, on a 63 mm outer diameter in 5", 10", 20", 30" and 40" lengths.

End caps are DOE or SOE (226 fin, 226 flat, 222 fin, 222 flat), with silicone, NBR, Viton or EPDM seals. Rated limits are 4 bar at 21°C and 2.4 bar at 80°C. The orange-peel cartridge shares the PLM specification with the groove type, used on high-solids feeds, and the mini-grooved surface, used for finer polishing. See the full melt blown filter cartridge range, or match it to industrial filter housings.

Características principales

• Orange-peel dimpled surface — added mechanical strength and rigidity under elevated differential pressure
• 100% polypropylene media — melt blown depth structure in 1, 3, 5, 10, 20, 30 or 60 µm
• Standard format — 63 mm OD in 5", 10", 20", 30" and 40" lengths
• Housing fit — DOE or SOE (226 fin, 226 flat, 222 fin, 222 flat) end caps; silicone, NBR, Viton or EPDM seals
• Rated limits — 4 bar at 21°C, 2.4 bar at 80°C; 80°C maximum temperature
• ISO 9001 manufacture

Aplicaciones

• Pre-filtration of high-viscosity process liquids
• Lines where differential pressure across the element runs high within its 4 bar rating
• Protection of pleated or membrane final filters downstream
• Industrial water pre-filtration where cartridge rigidity matters